Stops generating by itself
Hi!
My Sunbeam stops my GTIL2 from generating by itself. I generates as it should but then, after a short period, it turns generating off.
I can see on MQTT that it sets ion -> 0 and nothing has told it do to that.
How do I debug? Hardware failure? Bug in Sunbeam?
52 Views
Ok, thanks. I think ignoring err:6 and err:10 should work fine since the LCD display control mode doesn't stop generating when receives these errors. Since the manufacturer of these inverters didn't release any documentation on the data between the Display and Control boards, I can only change the SunBeam's firmware to behave the same way as how the Display board reacts as people are experiencing them just like what you did so I really appreciate your help.
However, this doesn't solve the issue of why you are getting these errors. It might be indicative of something is going bad or there's something probably on the AC side it doesn't like (the occasional 0 on the AC voltage). Anyways, I'll make the change to the firmware as verion 1.54 in about 5 minutes. I'll let you know and you can download it immediately using the debug method I mentioned earlier.